LTM4608A
APPLICATIONS INFORMATION
R FB4 ?
R SR ≥
V IN ?
CLKIN is tied to ground or if it’s driven by an external
frequency synchronization signal. A capacitor value of
0.01μF must be placed from the PLLLPF pin to ground to
control the slew rate of the spread spectrum frequency
change. Add a control ramp on the TRACK pin with R SR
and C SR referenced to V IN . Figure 21 shows an example
for spread spectrum operation.
1
? ? 0.592 ? ?
? ? ln ? 1 ? ? ? 500 ? C SR ?
? ? ?
Output Voltage Tracking
Output voltage tracking can be programmed externally
using the TRACK pin. The output can be tracked up and
down with another regulator. The master regulator’s output
is divided down with an external resistor divider that is the
same as the slave regulator’s feedback divider to implement
coincident tracking. The LTM4608A uses an accurate 10k
resistor internally for the top feedback resistor. Figure 5
shows an example of coincident tracking:
? 10k ?
Slave = ? 1 + ? ? V TRACK
?
V TRACK is the track ramp applied to the slave’s track pin.
V TRACK has a control range of 0V to 0.596V, or the internal
reference voltage. When the master’s output is divided
down with the same resistor values used to set the slave’s
output, this resistor divider is connected to the slave’s track
pin. The slave will then coincident track with the master
until it reaches its final value. The master will continue to
its final value from the slave’s regulation point. Voltage
tracking is disabled when V TRACK is more than 0.596V.
V IN
5V
V IN
SV IN
CLKIN
V OUT
C2
100pF
100μF
MASTER
3.3V
7A
TIE TO V IN
FOR DISABLE
AND DEFAULT
100μs SOFT-START
R SR C SR
RUN
TRACK
SW FB
LTM4608A
RUN I TH
PLLLPF I THM
TRACK PGOOD
MODE BSEL
R FB1
2.21k
C3
22pF
V IN
50k
APPLY A CONTROL
RAMP WITH R SR AND
C SR TIED TO V IN WHERE
t = –(ln (1 – 0.596/V IN ) ? R SR ? C SR )
OR APPLY AN EXTERNAL TRACKING RAMP
PHMODE MGN
CLKOUT GND SGND
50k
V IN
SV IN
CLKIN
V OUT
C1
100μF
+
C4
100μF
SLAVE
1.5V
8A
MASTER
3.3V
R FB3
10k
R FB4
6.65k
RUN
TRACK
SW FB
LTM4608A
RUN I TH
PLLLPF I THM
TRACK PGOOD
MODE BSEL
PHMODE MGN
CLKOUT GND SGND
R FB2
6.65k
4608A F05
Figure 5. Dual Outputs (3.3V and 1.5V) with Tracking
4608afd
15
相关PDF资料
LTM4608IV#PBF IC DC/DC UMODULE 8A 68-LGA
LTM4609IV#PBF IC BUCK/BOOST SYNC ADJ 4A 141LGA
LTM4612IV#PBF IC BUCK SYNC ADJ 5A 133LGA
LTM4613MPV#PBF IC UMODULE DC/DC 8A 133-LGA
LTM4614IV#PBF IC UMODULE DC/DC DUAL 4A 144LGA
LTM4615IV#PBF IC SWIT REG BUCK 4A ADJ 144LGA
LTM4618IV#PBF IC DC-DC UMODULE BUCK 6A 84-LGA
LTM4619IV#PBF IC SWIT REG BUCK 4A ADJ 144LGA
相关代理商/技术参数
LTM4608AEV#PBF 制造商:Linear Technology 功能描述:DC/DC MICRO MODULE IC
LTM4608AEVPBF 制造商:Linear Technology 功能描述:Conv DC-DC Single-OUT Step Down
LTM4608AEV-PBF 制造商:LINER 制造商全称:Linear Technology 功能描述:Low VIN, 8A DC/DC μModule with Tracking, Margining, and Frequency Synchronization
LTM4608AIV#PBF 功能描述:IC BUCK SYNC ADJ 8A 68LGA RoHS:是 类别:电源 - 板载 >> DC DC Converters 系列:µModule® 设计资源:VI-200, VI-J00 Design Guide, Appl Manual 标准包装:1 系列:* 类型:隔离 输出数:1 电压 - 输入(最小):55V 电压 - 输入(最大):100V Voltage - Output 1:5.8V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出(最大):* 电源(瓦) - 制造商系列:100W 电压 - 隔离:* 特点:* 安装类型:通孔 封装/外壳:9 针半砖 BusMod 尺寸/尺寸:2.36" L x 2.28" W x 1.08" H(59.9mm x 57.9mm x 27.4mm) 包装:散装 工作温度:-25°C ~ 100°C 效率:* 电源(瓦特)- 最大:*
LTM4608AIV#PBF 制造商:Linear Technology 功能描述:DC/DC MICRO MODULE IC
LTM4608AIV-PBF 制造商:LINER 制造商全称:Linear Technology 功能描述:Low VIN, 8A DC/DC μModule with Tracking, Margining, and Frequency Synchronization
LTM4608AMPV 制造商:LINER 制造商全称:Linear Technology 功能描述:Low VIN, 8A DC/DC μModule with Tracking, Margining, and Frequency Synchronization
LTM4608AMPV#PBF 功能描述:IC BUCK SYNC ADJ 8A 68LGA RoHS:是 类别:电源 - 板载 >> DC DC Converters 系列:µModule® 设计资源:VI-200, VI-J00 Design Guide, Appl Manual 标准包装:1 系列:* 类型:隔离 输出数:1 电压 - 输入(最小):66V 电压 - 输入(最大):160V Voltage - Output 1:12V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出(最大):* 电源(瓦) - 制造商系列:50W 电压 - 隔离:* 特点:* 安装类型:通孔 封装/外壳:9-FinMod 尺寸/尺寸:4.60" L x 1.86" W x 0.79" H(116.8mm x 47.2mm x 20.1mm) 包装:散装 工作温度:-25°C ~ 85°C 效率:* 电源(瓦特)- 最大:*